Two step with alky

Discussion in 'Bailey 2-Step Rev Limiter' started by Kirby, Sep 22, 2018.

  1. Kirby

    Kirby Member

    I just ordered a Bailey engineering 2-step from you. I'm running a 6.1 chip with alky injection. Do I need to bypass the alky while on the 2-step, also is it OK to be closed loop at wot with the 2-step? Thanks, Kirby.
     
  2. EricM

    EricM Administrator Staff Member

    For the 2-step, there are some tweaks that typically need to be made in the chip. Normally the alcohol does not need to be on, but if it works ok with it on, you can run it. The problem with keeping the alky off, is it might not ramp up fast enough once you launch. WOT closed loop only enables over about 10psi boost, so it depends on what boost you launch at, but generally we don't want closed loop when on the 2-step.
    Usually people will try it out as is, then if there's problems, we modify the chip programming.
     
    Kirby likes this.
  3. Kirby

    Kirby Member

    Thanks for replying. Once I install it, I'll see how it works out.
     

Share This Page