Scanmaster Temp reading

Discussion in 'AXiS Inteface - MAF Tuning Device' started by CenTex, Jan 15, 2019.

  1. CenTex

    CenTex New Member

    I have the AXiS box and chip installed, and followed the directions of splicing to the brown temp sensor wire, leaving the sensor unplugged. My Scanmaster reads 81-82 degrees back and forth. Is this normal or did I make a mistake?
     
  2. EricM

    EricM Administrator Staff Member

    Yes that is normal. It's not a real temp reading, just ignore it.
     
  3. CenTex

    CenTex New Member

    Thank you sir for the response- also I was getting a low AF reading, although the vehicle is running great, I’ve got an idle of 3-5 and WOT maybe 120. Is this chip similar to an extender with a half AF reading on the scanmaster or do I have another issue?
     
  4. EricM

    EricM Administrator Staff Member

    Yes, you need to double that reading.
     
  5. CenTex

    CenTex New Member

    Thanks again sir for the fast reply and great products! I appreciate it.
     

Share This Page